Graffiti Shield 1 Layer

Wax-based 1 layer anti-graffiti coating

Graffiti Shield 1 Layer

Fields of application

Graffiti Shield 1 L is a water-based wax emulsion that functions
as a single-layer anti-graffiti coating and can be used on surfaces that are often expo-sed to graffiti – e.g. in concrete underpasses.


– Protects against spray and paintbrush graffiti
– Prevents occurrence of hard to clean “graffiti shadows”
– Low melting point
– Permeable
– UV resistant

Application instructions

Start by cleaning the surface thoroughly to remove dirt, algae, traffic film, wax and any colour remnants from old graffiti.
Allow the surface to dry so that it is dry or slightly damp but not wet. NB! New concrete must harden for a minimum of 28 days before the anti-graffiti coating is applied.
When applying anti-graffiti coating to newly painted surfaces, allow the paint to dry for ap- prox. 1 – 4 weeks before application takes place.
Shake the product prior to use! Apply the product using an airless or low-pressure spray gun or roll it on with a roller. If the product runs, even it out with a paintbrush.
The treated surface must have a minimum temperature of approx. 2°C. Drying time is 1-4 hours depending on the temperature.
After treatment, it is easier to remove graffiti or other undesired residues with a pressure washer (70-150 bar) and hot water (approx. 65°C). Adjust pressure to the facade.
A new layer of the product is then applied to the cleaned surface, which is subsequently protected against graffiti again.
NB! The surface may appear darker and glossier after treatment.

Before you begin – Always evaluate the product on each surface to be treated, for suitability and results before overall application. It is important to include previous repairs and repairs in the test area. Different materials / surface compositions can result in absorption and / or appearance differences. Also test the application speed, pattern and technology needed to obtain a smooth surface.


The product is used in concentrated form. Highly absorbent surfaces: 3 – 4 m2 per litre Less absorbent surfaces: 5 – 6 m2 per litre


301027 – 25L

The product image should be seen as an illustration. Some deviation from reality may occur.