GR Blue is used to remove graffiti from absorbent surfaces such as brick, granite, concrete, marble, terrazzo, slate, sandstone, limestone, tiles etc.

Advantages

• Effective on both spray doodles, felt-tip pens and tectyl
• Slight odor
• Thin liquid
• Easy to rinse off
• Economical in use

Application instructions

Apply the product with a paintbrush, brush, roller or paint sprayer. Allow the product to work for 10 – 2 hours depending on the nature of the graffiti. Use a brush or paintbrush on the surface to ensure that the paint is dissolved. Then wash off the surface thoroughly using a hot water pressure washer and adjust the pressure to the facade. In cases where a “shadow” remains, it can be necessary to use either GR Shadow or GR Kilroy.

Note: Never apply on hot surfaces and prevent drying.
Use caution on repainted and sensitive metal and plastic surfaces.
Sample washing is recommended.

Dosage

The product is used in concentrated form. Consumption approx. 0.3 – 0.5 litre/m2.

Packaging

331025 – 25L
331700 – 1000L

The product image should be seen as an illustration. Some deviation from reality may occur.

The post Graffiti Remover Blue Flytande appeared first on Blue and Green.

A very effective graffiti and shadow remover to be used in cold weather and on difficult graffiti. Can be used on porous surfaces such as: granite, brick, concrete, lime, tiles, etc. The product dissolves spray graffiti, permanent markers and marker scribbles. For use on porous external surfaces.

Note! Do not use on metal surfaces such as aluminum. Do a test before removal.

Advantages

– Combination product
– Efficient

Application instructions

Apply with a brush. Agitate the surface well. Leave until the graffiti is dissolved, 10-30 minutes depending on the surface, graffiti and weather conditions. Rinse with hot water and high pressure, 90°C, 150 bar/2175 PSI or adapt to the surface. The spread of the lance nozzle should be 15 – 25 degrees and the water flow should be 15 to 20 liters/minute (4-5 gal/minute). For shadows, apply as a shadow remover, wait 5-10 minutes before rinsing with high pressure. Final rinse with low pressure.
Store frost-free in closed original packaging.

Note: Never apply on hot surfaces and prevent drying.
Use caution on repainted and sensitive metal and plastic surfaces.
Sample washing is recommended.

Dosage

Used concentrated.
Shake/stir before use

Consumption: 0.5 – 1.0 litres/m²

Packaging

026010 – 10L

The product image should be seen as an illustration. Some deviation from reality may occur.

The post Graffiti Remover Eden Gel appeared first on Blue and Green.

Ideal for removing residues from concrete and lime, as well as for removing flight rust and rust. It is also effective for cleaning and neutralizing oxidized surfaces on galvanized material. In the mining sector, it is used as a cleaner for vehicles. Its ability to deep-clean dirt-coated concrete floors, wall surfaces, and sheet facades makes it particularly useful in mining and paper production, without causing damage to aluminum, glass, rubber, painted surfaces, and similar materials.

Application instructions

The product is easily applied with a brush and should be left to act for between 15 and 90 minutes. Afterwards, the surface should be scrubbed with a brush followed by rinsing with a high-pressure washer. As long as the product is wet, it is in an active state and can be effectively used for up to 3 hours. One liter of the product covers an area of approximately 8 to 12 square meters. It is important that the temperature where the product is used exceeds +3°C for optimal results.
Gel Hammer has the ability to break down layers of concrete residue up to 6 mm thick.

Packaging

061025 – 25L
061200 – 200L

The product image should be seen as an illustration. Some deviation from reality may occur.

The post Gel Hammer appeared first on Blue and Green.

Used to remove graffiti from industrial painted surfaces such as trains, subways, trams, buses, metal facades, etc.
Works great even on absorbent materials where you have a sensitive painted surface to take into account when cleaning.

Advantages

– Effective on spray paint and marker graffiti.
– Gentle on underlying surfaces and materials
– Subtle scent
– Economical

Application instructions

Apply the product with a cloth or brush and try to wipe off the graffiti immediately- Wipe / rinse the surface with water-
For heavier graffiti, let the product work for 2-3 minutes and work the surface with a cloth or brush to ensure that the color is dissolved.
Thoroughly wipe/ rinse the surface with water so that the product stops working on the underlying material.

Note: Never apply on hot surfaces and prevent drying.
Use caution on repainted and sensitive metal and plastic surfaces.
Sample washing is recommended.

Dosage

The product is used in concentrated form. Consumption approx. 0.1 – 0.3 litre/m2.

Packaging

336006 – 5L
336010 – 10L
336025 – 25L
336700 – 1000L

The product image should be seen as an illustration. Some deviation from reality may occur.

The post Graffiti Remover 21 Flytande appeared first on Blue and Green.

Graffiti remover. Used to remove marker, ink, spray paint, etc. Mr. Perfect is used on all hard and soft colourfast and material-based surfaces such as floors, facades, tiles, metals, textiles, etc.

Advantages

• Low odor
• Aromatic free

Application instructions

Leave the product on for 1-30 seconds. Draw away or rinse away undissolved residual product. Always finish by rinsing with clean water. For tough stains, let the product work for 1-10 min, process the stain with a brush and finish with water. ATTENTION! Avoid Mr. Perfect on macrolon, ABS plastic, silk, suede and leather. Unsure if the surface is colorfast or material permanent, try first on a less visible place.
Note: Never apply on hot surfaces and prevent drying.
Use caution on repainted and sensitive metal and plastic surfaces.
Sample washing is recommended.

Dosage

Ready to use, do not dilute

Packaging

224003 – 1L

The product image should be seen as an illustration. Some deviation from reality may occur.

The post Mr Perfect appeared first on Blue and Green.

Used to remove old paint from most surfaces such as mortar, plaster, brick, concrete, tile, wood and metal. Solves both plastic paints and oil paints.

Advantages

– Highly effective on multi-layered old paint
– Subtle scent
– Gel that prevents rapid drying out
– Easy to wash off
– Economical

Application instructions

Always stir the product thoroughly before use.
Always test function on a small test surface (10 x 10 cm) first.
Apply the product in a thick layer with a brush, roller or paint sprayer. The layer on the product must be thicker than the paint layer to be removed. Let the product work in 30 minutes – 24 hours depending on the type and thickness of the paint and the outside temperature.
Do not allow the product to dry!
The product can be covered with construction plastic to give increased duration and effect. Check that the paint is completely dissolved by doing a scratch test and make sure that you can easily scrape down to the surface before removal can begin.
Dissolved paint is removed with a scraper, brush or hot water high pressure washer.
When washing start from below and work upwards – finish by rinsing the cleaned surface thoroughly with clean water from top to bottom. Repeat the treatment if necessary.

Note: Never apply on hot surfaces and prevent drying.
Use caution on repainted and sensitive metal and plastic surfaces.
Sample washing is recommended.

Dosage

0.5 – 1.0 litre/m2.

Packaging

328015 – 15L

The product image should be seen as an illustration. Some deviation from reality may occur.

The post Paint Remover Red appeared first on Blue and Green.

Chewing Gum Remover is used to remove chewing gum residues on hard and soft colorfast surfaces.

Advantages

• pH-neutral
• Can be used on all surfaces without causing damage
• Gives fast results

Application instructions

Spray the product directly on the surface where chewing gum residues are present and leave to work for 1-5 min. Use a plastic scraper to removve the dissolved gum. For heavier chewing gum residue let the product work longer. Finish the work through to clean the surface with a damp cloth or glass cleaner. Check that the material is durable the product. Shake before use.

Dosage

Use concentrated

Packaging

3871048 – 0,5L

The product image should be seen as an illustration. Some deviation from reality may occur.

The post Chewing Gum Remover appeared first on Blue and Green.

Graffiti Remover is used to remove graffiti on hard, colourfast surfaces such as laminate, glass, metal, tiles etc.

Advantages

– Effective against marker graffiti, silver/gold pens and ink pens – Also removes lighter “shadows” left by marker graffiti – Gentle on underlying surfaces and materials – Subtle scent – Fast-acting

Application instructions

Spray the product on a clean cloth or directly on the graffitied surface and wipe away the graffiti.
Then wipe off the surface with a damp cloth or glass cleaner.
For more severe graffiti, allow the product to work for 1-5 minutes and then wipe off the surface with a cloth or white scouring pad – then wipe off/wash the surface carefully with damp cloth or glass cleaner so that the product does not affect the underlying material.

Note: Never apply on hot surfaces and prevent drying.
Use caution on repainted and sensitive metal and plastic surfaces.
Sample washing is recommended.

Dosage

The product is used in concentrated form. Consumption approx. 50-100 ml/m2.

Packaging

253005 – 5L
3871046 – 0,5L

The product image should be seen as an illustration. Some deviation from reality may occur.

The post Graffiti Remover appeared first on Blue and Green.

GR Wipes are used to remove graffiti from hard, colourfast surfaces such as laminate, glass, metal, tiles etc.

Advantages

– Effective against marker graffiti, silver/gold pens and ink pens
– Also removes lighter “shadows” left by marker graffiti
– Gentle on underlying surfaces and materials
– Subtle scent
– Fast-acting and does not run

Application instructions

Pull a paper wipe out of the container and wipe away graffiti.Then wipe the surface with a damp cloth or glass cleaner.
For more severe graffiti, allow the product to work for 1-5 minutes and apply the paper wipe to the surface. Then wipe off/wash the surface carefully with a damp cloth or glass cleaner so that the product does not affect the underlying material.
NB! Check that the material can tolerate the product. Not for use on plexiglass! Close the package properly in order to prevent the product from drying out.

Note: Never apply on hot surfaces and prevent drying.
Use caution on repainted and sensitive metal and plastic surfaces.
Sample washing is recommended.

Dosage

The product is used in concentrated form. Consumption approx. 1 paper wipe/m2.

Packaging

384056 – STK

The product image should be seen as an illustration. Some deviation from reality may occur.

The post Graffiti Remover Wipes appeared first on Blue and Green.

Ink Remover is used to remove graffiti from fragile surfaces and materials such as plastic, laminate, fibreglass, signs etc. Also suitable for cleaning absorbent materials with fragile painted surfaces.

Advantages

– Effective on spray paint, marker and Tectyl graffiti
– Gentle on underlying surfaces and materials
– Subtle scent
– Economical

Application instructions

Apply the product with a cloth and try to wipe off graffiti immediate- ly using small circular motions – then wipe off/wash the surface thoroughly with water or a glass cleaner.
For more severe graffiti, allow the product to work for 2-3 minutes and then wipe the surface with a cloth to ensure that the paint is dissolved – then wipe off/wash the surface carefully with water or glass cleaner so that the product does not affect the underlying material.

Note: Never apply on hot surfaces and prevent drying.
Use caution on repainted and sensitive metal and plastic surfaces.
Sample washing is recommended.

Dosage

The product is used in concentrated form. Consumption approx. 0.1 – 0.3 litre/m2.

Packaging

3832005 – 5L

The product image should be seen as an illustration. Some deviation from reality may occur.

The post Ink Remover appeared first on Blue and Green.